white lithium grease.
small philips screw driver
normal philips screw driver
and a small hammer
white towel (optional) to not lose parts.
here we are:
After we gather our supplies we will get to business. So first off we’ll release our slide by pulling down on either side where my thumbs are and pulling back then forward.
after this we pull out our spring and barrel assembly.
next we unscrew this Philips screw with a smaller Philips screw driver near the back of the upper slide
after we unscrew the screw. Flip over your upper slide and your loading nozzle assembly will come out.
next pull on the loading nozzle. Make sure to not bend these springs they are needed (VERY IMPORTANT.
push the pin out on the LEFT side. This is a ONE WAY PIN.
your spring and (unknown part name) will FLY out. Make sure you don’t lose these!
get out soapy water and clean your loading nozzle
dry the loading nozzle off.
clean your loading nozzle assembly and oil it with silicon oil. Not too much.
next after oiling put it all back together.
the pin goes in from right to left. You’ll need to push in the spring and part and do the pin at the same time.
next put it in the loading nozzle assembly and put the springs in last.
then put it in the slide. There’s a trick to this. The spring needs to get in. so basically it goes in loading nozzle side first then down.
then screw it down.
now to the barrel and hop up. This is a little tricky.
push the pin out near the bottom of the hop up assembly make sure to not lose the spring it’s tiny!
now pull out on the right side of the hop up assembly. It will pull apart. Make sure to not lose the ball bearing.
now clean and do whatever you want and assemble again.
now clean your slide and clean your recoil spring. Then oil it and assemble.
now to the lower frame/slide.
punch out the pin at the bottom of the gun
then punch out the hammer pin
then you can clean your hammer and do whatever here. And we can assemble.
watch out for the spring and sear I believe.
then assemble. After oiling the pins go from right to left.
Now get out the White lithium oil
oil your slides lightly and then wipe with q-tip. Make sure that it is oiled just right.
Assemble and DONE! You have a clean, oiled KWA ATP
All done by me. You’re welcome guys.
start from the bottom and go up sorry i tried to attach the files to the post, but i couldn't do it guys
Edited by musicianairsofter, 23 October 2012 - 02:24 PM.