Jump to content


HELP! MAJOR PROBLEM!

mp7 kwa pin take down dissasembly

  • Please log in to reply
5 replies to this topic

#1 gregwhite52

gregwhite52

    Newbie

  • Members
  • Pip
  • 13 posts
  • Country:

Posted 05 August 2012 - 11:20 AM

Help! The top body pin on my mp7 rotated while in the gun about 30 counter clockwise and now the tension spring doesn't line up with the groove and it is impossible to take the pin out! I CANNOT TAKE THE GUN APART!!

#2 General Pickle

General Pickle

    Specialist

  • Members
  • PipPipPip
  • 313 posts
  • Gender:Male
  • Location:Oregon
  • Interests:tactical stuffs(airsoft, real steel, knives etc.), mechanical and manufacturing engineering, computers, gaming, the great outdoors
  • Country:

Posted 05 August 2012 - 12:21 PM

I had this problem too. I wish I could give a detailed explanation of how to get it out but it really just took a lot of patience and thinking. Brute force will NOT work. Finding the right tool to release the tension of the locking spring is the hard part, after that it's a piece of cake.

#3 gregwhite52

gregwhite52

    Newbie

  • Members
  • Pip
  • 13 posts
  • Country:

Posted 05 August 2012 - 01:20 PM

So how did you fix it, and or what tool did you use???

#4 optimuskmg

optimuskmg

    Enthusiast

  • Members
  • PipPip
  • 293 posts
  • Gender:Male
  • Location:Bridgewater
  • Country:

Posted 05 August 2012 - 04:40 PM

this also happened to mine. i did a brute force job and i scratched up the body, which i dont recomend. get like a hook, thats small enough to fit inside, and release the spring and it should slide out. then just take them out. there not really important.

#5 Outlaw1995

Outlaw1995

    Guru

  • Members
  • PipPipPipPip
  • 1,713 posts
  • Gender:Male
  • Interests:Acting, Piano, Films, Theatre, Firearms, Knives, Airsoft
  • Country:

Posted 05 August 2012 - 04:55 PM

I had the same problem... except my pin was a whole 180 degrees away from the little notch. So, I took some pliers, grabbed hold of the pin and rotated it and pulled up and rotated some more until it finally lined up with the notch so it could be taken out. Just be patient and don't give up!

#6 Sigp226

Sigp226

    Newbie

  • Members
  • Pip
  • 22 posts
  • Gender:Male
  • Location:Socal (OC)
  • Country:

Posted 05 August 2012 - 09:43 PM

Yep what Outlaw said, pliers and some patience did it for me!





Also tagged with one or more of these keywords: mp7, kwa, pin, take down, dissasembly

0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users