Jump to content


Mag disassembly


  • Please log in to reply
1 reply to this topic

#1 Oldskool

Oldskool

    Newbie

  • Members
  • Pip
  • 19 posts
  • Gender:Male
  • Country:

Posted 24 June 2012 - 04:35 AM

I have to replace the feed ramp on one of my ATP mags, and would like some disassembly instructions. It looks like 2 roll pins, but how do they remove...pin punch? Which side to punch them out from?

Just as an FYI, the feed ramps seem provide the same aerodynamic properties as butter on toast if you miss the dump pouch and drop these things...especially if it's indoors on concrete!

-Oldskool

#2 gcw360

gcw360

    Supreme Guru

  • Super Moderator
  • PipPipPipPip
  • 11,738 posts
  • Gender:Male
  • Location:New Jersey
  • Interests:Airsoft (Especially repair and customizing), Fly Fishing, Fossils (Especially Dino), Snakes, Photography
  • Country:

Posted 24 June 2012 - 05:49 AM

There is one pin at the top that you need to drive out, part MG8..  I always go left to right, looking at the release valve, but these pins do not have a particular direction if memory serves.  It is a straight pin so the correct standard punch should work.

See parts diagram: http://kwausa.com/fi...MV01_ATPmag.jpg




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users