Jump to content


How To Remove The Inner Barrel?


  • Please log in to reply
4 replies to this topic

#1 Raptor72

Raptor72

    Enthusiast

  • Members
  • PipPip
  • 189 posts
  • Gender:Male
  • Location:Annapolis, MD
  • Country:

Posted 21 May 2012 - 08:42 AM

For those who already have their gun.  Have any of you taken the inner barrel out yet?

#2 jpip

jpip

    Specialist

  • Members
  • PipPipPip
  • 324 posts
  • Gender:Male
  • Interests:Air rifles, Airsoft, Coaching Softball, Ice Hockey, and Family Time.
  • Country:

Posted 21 May 2012 - 02:15 PM





Check these out. you need to know how to do this for imperative barrel and bucking cleaning. It's really simple, just follow directions and take your time. Be careful with the bucking.

I've done this about 10 times between my 2 guns and It takes me around 5 minutes to disassemble, clean, and reassemble.

#3 Outlaw1995

Outlaw1995

    Guru

  • Members
  • PipPipPipPip
  • 1,713 posts
  • Gender:Male
  • Interests:Acting, Piano, Films, Theatre, Firearms, Knives, Airsoft
  • Country:

Posted 21 May 2012 - 03:05 PM

The links posted above are for cleaning an AEG bucking and barrel, while cleaning the barrel is the same, the bucking and hop up assemblies are different between the AEG and GBBR. I believe there's two screws you must unscrew to get to the inner barrel, but I'm not sure. Give me a few more weeks and the LM4 tear down will be up soon.

#4 jpip

jpip

    Specialist

  • Members
  • PipPipPip
  • 324 posts
  • Gender:Male
  • Interests:Air rifles, Airsoft, Coaching Softball, Ice Hockey, and Family Time.
  • Country:

Posted 21 May 2012 - 03:56 PM

Whoops....my bad. Wrong section :blinded:

#5 Raptor72

Raptor72

    Enthusiast

  • Members
  • PipPip
  • 189 posts
  • Gender:Male
  • Location:Annapolis, MD
  • Country:

Posted 21 May 2012 - 04:26 PM

Thanks for Input jpip.  I have been completely disassembling my SR10 for over a year, my issue is with the new LM4.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users