Posted 31 March 2012 - 08:53 AM
A couple of weeks ago I went out to try my g36c for the first time in an actual game. The hop-up was surprisingly over-hoping .25's. .28's run perfect with the hop up dial all the way down. I decided I would take a look at bucking and the nub. I cleaned the bucking in warm soapy water, re-seated the nub, then shined a flashlight into it and tested that the dial was working. I noticed after turning the hop-up up works fine but when I turn it back down the little fins only go up about half way from "all the way off" and I half to push all the way up with something. I then went to go test it after pushing the nub all the way up and reassembling everything. It still over hoped .25's the same way it did before. I am also seeing some inconsistent "hoping" of the bb's, Every few rounds one or two bb's will either have more hop or less hop then the rest. I am using tsd .28's and tsd .25's (These are the only bb's my local store sells). What could be the issue here and how can I fix this? I also don't have any local repair shops around so thats out of the question. If I have to send it anywhere it would have to be straight to KWA.