Jump to content


Mag Valve Stuck?


  • Please log in to reply
6 replies to this topic

#1 slips73

slips73

    Enthusiast

  • Members
  • PipPip
  • 36 posts
  • Country:

Posted 13 January 2012 - 02:06 PM

alright i think i finally figured out why my gun has been acting up, its the magazine...now today i was shooting and all of the sudden it stopped, the valve on the back of the magazine is stuck out...and the trigger hits it but it wont move i cnt even press it with my thumb? whats wrong? also my gun seems to be very innaccurate and hop up does nothing, i bought a new hop up and same problem, would this be the magazines fault?

#2 niko_gpsy

niko_gpsy

    What's a Warranty?

  • Super Moderator
  • PipPipPipPip
  • 5,880 posts
  • Gender:Male
  • Location:Atlanta, GA
  • Interests:Keeping those damn squirrels from putting their filthy little paws on my peaches in my backyard. Oh, Yes. It's not just a hobby, its a passion!!
  • Country:

Posted 13 January 2012 - 03:40 PM

You may have to take the release valve out and inspect to see whats causing the problem.  Even a slight scratch on the release valve button can render it useless.  And your mag very well can cause inaccuracies if not enough gas is released for a full cycle which can cause the bb's to drop off at short distances.
I usually take my valves out once in awhile to clean and relube for routine maintenance.

#3 slips73

slips73

    Enthusiast

  • Members
  • PipPip
  • 36 posts
  • Country:

Posted 13 January 2012 - 04:59 PM

oh also my copper spring that holds the block that holds the slide in broke so my gun is ultimately useless

#4 niko_gpsy

niko_gpsy

    What's a Warranty?

  • Super Moderator
  • PipPipPipPip
  • 5,880 posts
  • Gender:Male
  • Location:Atlanta, GA
  • Interests:Keeping those damn squirrels from putting their filthy little paws on my peaches in my backyard. Oh, Yes. It's not just a hobby, its a passion!!
  • Country:

Posted 13 January 2012 - 05:03 PM

And what part is that?

#5 slips73

slips73

    Enthusiast

  • Members
  • PipPip
  • 36 posts
  • Country:

Posted 13 January 2012 - 05:19 PM

part 66 its on the lower frame and is the little copper colored metal thing that can come out..it holds up part 26 for the slide

#6 gcw360

gcw360

    Supreme Guru

  • Super Moderator
  • PipPipPipPip
  • 11,596 posts
  • Gender:Male
  • Location:New Jersey
  • Interests:Airsoft (Especially repair and customizing), Fly Fishing, Fossils (Especially Dino), Snakes, Photography
  • Country:

Posted 13 January 2012 - 07:16 PM

That is the take down lever spring and take down lever.  If the spring is broken, the gun should be sent to KWA for repair.  I suggest that you jump on the help desk and start a ticket. By sending the gun in you can guaranty that it is fixed correctly.

#7 slips73

slips73

    Enthusiast

  • Members
  • PipPip
  • 36 posts
  • Country:

Posted 13 January 2012 - 08:11 PM

Yah I did that will be shipping it out tomorrow




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users