Gun Hard To Cock, Very Little Gas On Firing.
Posted 16 August 2011 - 04:09 PM
I dove into it and after poking around for a little bit I found the problem, the cast in pivot pin on the hammer broke on the ejection port side. It was tough to find because the hammer cocked fine by hand (meaning I pulled it back with my finger to cock it and fire it) but it would rotate enough when fired to barely hit the gas valve.
I am just going to drill it out and install a steel roll pin but this is something to keep an eye out for, and was difficult to see that it was broken.
Posted 16 August 2011 - 06:26 PM
Posted 17 August 2011 - 07:30 AM
Here it is with the new part pressed in, and the old broken piece next to it, works like a charm:
Posted 11 February 2012 - 02:02 PM
Posted 18 February 2012 - 06:27 AM
Posted 18 February 2012 - 03:07 PM
Posted 20 February 2012 - 11:56 PM
Posted 21 February 2012 - 06:11 AM
Posted 22 February 2012 - 03:55 PM
Posted 22 February 2012 - 05:07 PM
Posted 23 February 2012 - 01:03 AM
Posted 24 February 2012 - 11:10 PM
Posted 25 February 2012 - 07:56 PM
Posted 14 January 2013 - 06:04 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users