wong fei hung, on May 22 2008, 10:31 AM, said:
After unjamming my M4 S I applied some airsoft gun lube as per normal procedure in the manual and held it vertical while applying just a spray. After holding it vertical for about a minute or two to let the lube run into the piston I fired off 3 dry shots on semi as per instruction. Next I loaded the mag and fired off about 50 shots on auto to test out lube. After the 50 shots the gun stopped working altogether whether I switched to semi, safe, or auto. The fuse was fine, and the battery was full. I left it for a few hours and went back to test fire it again. It fired 4 shots before stopping dead again. Next day I go to test and it is now working but I have yet to test it for extended periods. Does anyone know if this is normal or if I am doing anything wrong? Please help where you can as I love my KWA AEG.
U should shoot on full auto and semi auto alternating for about 500-600 shots. If it happens again u should look at ur wiring, the lube could have somehow made it to ur wiring, if its touching any tips of the wiring that = BAD! If thats not it than ur should check ur gears and see if there aligned properly. IF thats not working than I dont know unless the motors making a bauging sound.