Jump to content


1911 Mark Ii Impact Pin


  • Please log in to reply
2 replies to this topic

#1 joeydudeman

joeydudeman

    Newbie

  • Members
  • Pip
  • 16 posts
  • Country:

Posted 26 June 2011 - 06:01 PM

Upon trying to figure out why my pistol hasn't been firing, I discovered upon pulling the hammer back that it seemed there were to be two pins there. A large black one which was there and, I believe, another which wasn't. Now, I'm gonna guess that's the infamous impact pin that I saw some reports of failure on. And second, since the part alone apparently costs some 1.50$, how do you reinstall it? Thanks in advance.
EDIT: It is in fact the impact pin, part 60. So what do you just pop it in? Gah I have a feeling this has a simple solution but I'd rather have a definitive answer than try to do it my self and break the f***ing thing.

Edited by joeydudeman, 27 June 2011 - 07:28 AM.


#2 joeydudeman

joeydudeman

    Newbie

  • Members
  • Pip
  • 16 posts
  • Country:

Posted 26 June 2011 - 06:05 PM

Edit: Fail post sorry

Edited by joeydudeman, 26 June 2011 - 06:05 PM.


#3 BrendanBone

BrendanBone

    Newbie

  • Members
  • Pip
  • 21 posts
  • Gender:Male
  • Country:

Posted 13 August 2011 - 08:19 PM

Yo bro i had the same problem


What you do is you field strip it, hold the front of the pistol towards you, and pull the hammer that strikes the gas release back towards you. Then take an awl or some small pointy object and push the pin back through the hole.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users