Jump to content


Messed Up My Cylinder Spring!


2 replies to this topic

#1 Coin3

Coin3

    Newbie

  • Members
  • Pip
  • 19 posts

Posted 13 March 2011 - 06:28 PM

Posted Image


So... I was putting the blockback assembly back in, and that happened. It got pinched on the side.
And now it doesn't work right, at all.

http://store.kwausa....urnsprings.aspx

Is this the exact same thing? The  pro shop is nada on KZ75 parts, and this is is ns2 too so I think it should fit.
My warranty is and has been over for months now, so I will pay whatever the cost.

#2 Spiggy

Spiggy

    Member

  • Members
  • PipPipPipPip
  • 2,136 posts
  • Gender:Male
  • Location:City of Industry
  • Country:

Posted 13 March 2011 - 09:36 PM

The one for the M9PTP should be roughly the same length and tension.  They all run off essentially the same engine so you should be fine with them.  

I would suggest lightly gluing the ends of the springs to their pegs so they don't pop off and get mangled during disassembly.

#3 Coin3

Coin3

    Newbie

  • Members
  • Pip
  • 19 posts

Posted 14 March 2011 - 02:49 PM

Thanks, I'll order it and maybe an extra set in the next few days when I can, just in case I do it again.



Reply to this topic



  


0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users