Kmp9 Bolt Dis-Assembly
Posted 21 February 2011 - 06:23 AM
note: When using a punch to remove pins use the smallest hammer you have, and always punch the pin out so the knurled side is visible as you are pushing the pin out. It is a bit larger than the rest of the pin to help secure it in place, but once it is free the pin should move much easier.
Start by removing the screw in the front of the gun above the barrel, black arrow is pointing to it in the following picture:
Next lift off the upper dust cover by pushing in the spring guide at the back of the dust cover and lift from the front:
Remove the bolt as per the instructions in your owners manual:
Using a 1.5mm punch and having the bolt supported so the pin has someplace to go gently tap out the pin that striker plate is pivoting on (note the black arrow indicating the knurled part of the pin):
Now gently tap out the two smaller pins:
Now the cylinder assembly should easily slide out the back, be careful of the two springs on the top of the cylinder:
Pop the springs off and the cylinder will slide free:
Now we can remove the valve, yours will look different than mine, I have a KWA MP7 valve in mine to reduce fps by about 30:
Push the pin out being sure to push the side out that is knurled, this part is plastic so use very little tapping force here, I could push mine out with just my hand and the punch, no hammer needed:
The valve and spring should now come out:
That is all there is too it!
Posted 21 February 2011 - 01:02 PM
edit: I asked this in the Pro Shop section of the forums, but does KWA have any of those plastic MP7 nozzles laying around somewhere? Maybe in a dark corner? I really need to reduce my FPS, it's quite painful here in mississippi on a hot day :/
edit2: I already tried ordering one but I was sent the aluminum one.
Edited by MatthewTyson, 21 February 2011 - 01:07 PM.
Posted 21 February 2011 - 04:09 PM
Posted 21 February 2011 - 06:31 PM
Thanks bud. I've done the other parts on my pistols many times to clean them but I wasn't sure how to get the cylinder out. Easy peezey now that you've shown us!
Posted 21 February 2011 - 10:47 PM
Posted 02 March 2011 - 12:55 PM
Edited by BlackCloud, 02 March 2011 - 12:56 PM.
Posted 03 March 2011 - 05:02 AM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users