Jump to content


Has anyone used G&P Magazines with their KWA M4?


  • Please log in to reply
23 replies to this topic

#21 Howie

Howie

    Newbie

  • Members
  • Pip
  • 20 posts
  • Location:Milton, Florida
  • Interests:Marine Engineering, Fishing, travel, Airsoft

Posted 09 October 2008 - 01:55 PM

The G&G work good for me, 79 round and 130 round magazines, not sure which one it was but you able to shot all b.b.'s due to the design. they are a tight fit but a little bit of sand paper solves the problem.

#22 Guest_allizard_*

Guest_allizard_*
  • Guests

Posted 10 October 2008 - 12:46 AM

View PostHowie, on Oct 9 2008, 02:55 PM, said:

The G&G work good for me, 79 round and 130 round magazines, not sure which one it was but you able to shot all b.b.'s due to the design. they are a tight fit but a little bit of sand paper solves the problem.

Can you take a picture of your G&P mag and show us exactly where did you sand it down? It will be very helpful.

#23 Doctor Kajita

Doctor Kajita

    Enthusiast

  • Members
  • PipPip
  • 163 posts
  • Location:San Francisco, CA

Posted 14 October 2008 - 12:19 AM

View Postallizard, on Oct 9 2008, 09:31 AM, said:

Sector clip help increase the timing on the tappet plate, en-sure a better feeding of bbs into the chamber.  Especially when you are shooting in high speed.

My sector gear has a small round piece on it.  Is that a sector clip?  I'm looking around and pics of sector clips do not look like the one on my sector gear.  Is there an updated one from KWA or is the one on mine it?  

I presume I can buy one that's "Marui" compatible for AEG's and it'll fit.

#24 vic_man4

vic_man4

    Specialist

  • Members
  • PipPipPip
  • 591 posts
  • Location:Niagara, Ontario, Canada
  • Interests:Airsoft, XBox 360 (GamerTag = CovertMaz), Cars, and HEAVY METAL \m/

Posted 14 October 2008 - 05:49 PM

View PostDoctor Kajita, on Oct 14 2008, 12:19 AM, said:

My sector gear has a small round piece on it.  Is that a sector clip?  I'm looking around and pics of sector clips do not look like the one on my sector gear.  Is there an updated one from KWA or is the one on mine it?  

I presume I can buy one that's "Marui" compatible for AEG's and it'll fit.

Is that round piece on the nub that usually engages the tappet plate? If so then yeah, your looking at it.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users