Jump to content


Looking to put a 1 piece Madbull Outer Barrel on my KM4 CQB


  • Please log in to reply
2 replies to this topic

#1 Infect1D

Infect1D

    Newbie

  • Members
  • Pip
  • 26 posts

Posted 02 October 2008 - 11:02 AM

I purchased a KM4 CQB a while ago and I'm in love with it. However, I am looking to give it the full look of an M4, and seeing as how I don't play CQB, I'd like to get a longer barrel. I did a little bit of looking around and found this barrel made by Madbull on ASGI:

http://www.airsoftgi...roducts_id=2725

ASGI says the barrel is compatible with most M4's, but I'd like to be sure that it'll fit in my KWA. Thanks in advance for any help!

#2 Guest_allizard_*

Guest_allizard_*
  • Guests

Posted 02 October 2008 - 11:47 AM

View PostInfect1D, on Oct 2 2008, 12:02 PM, said:

I purchased a KM4 CQB a while ago and I'm in love with it. However, I am looking to give it the full look of an M4, and seeing as how I don't play CQB, I'd like to get a longer barrel. I did a little bit of looking around and found this barrel made by Madbull on ASGI:

http://www.airsoftgi...roducts_id=2725

ASGI says the barrel is compatible with most M4's, but I'd like to be sure that it'll fit in my KWA. Thanks in advance for any help!

I have the Madbull outer barrel.  It a tight fit but it will go in our receiver.  And technically it is not a complete one piece since you still need to tighten the set screw one on top and one on bottom.

#3 Infect1D

Infect1D

    Newbie

  • Members
  • Pip
  • 26 posts

Posted 02 October 2008 - 12:27 PM

View Postallizard, on Oct 2 2008, 03:47 PM, said:

I have the Madbull outer barrel.  It a tight fit but it will go in our receiver.  And technically it is not a complete one piece since you still need to tighten the set screw one on top and one on bottom.

Thanks for the help Allizard, I appreciate it!




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users