Jump to content


Service Advisory - Loose Top Rail on Receiver


  • Please log in to reply
23 replies to this topic

#21 IHB97

IHB97

    Newbie

  • Members
  • Pip
  • 1 posts
  • Country:

Posted 19 February 2012 - 04:42 PM

Where could I get these shims at?

#22 gcw360

gcw360

    Supreme Guru

  • Super Moderator
  • PipPipPipPip
  • 11,651 posts
  • Gender:Male
  • Location:New Jersey
  • Interests:Airsoft (Especially repair and customizing), Fly Fishing, Fossils (Especially Dino), Snakes, Photography
  • Country:

Posted 19 February 2012 - 06:03 PM

An Airsoft store.  They are gear shims.

#23 Disrupter911

Disrupter911

    Enthusiast

  • Members
  • PipPip
  • 32 posts
  • Gender:Male
  • Location:NJ
  • Interests:Firearms | Airsofting | Photography | Gaming | 360&PC | Motorsports
  • Country:

Posted 18 April 2013 - 03:07 PM

What exactly are you using for a spacer in that picture?
nylon washer from home depot or somewhere?

guess I should read until the end of the thread. gear shims it is!

#24 msgall2003

msgall2003

    Newbie

  • Members
  • Pip
  • 18 posts
  • Country:

Posted 11 January 2014 - 03:47 PM

Yeah, I suppose this could work.... sort of. I notices the same issue on my LM4C. My fix is a bit more permanent however. Since upper receivers are relatively inexpensive, I chose to just remove the rail and apply JB Weld to all of the contact areas. I cleaned everything with some rubbing alcohol and then carefully applied the compound in the channels on the underside of the rail where it meets the two upper receiver halves. Then I reassembled everything during which I carefully pressed everything together to squeeze the excess amounts out, drove the roll pin in then used q tips, toothpicks, and paper towels to remove anything the squeezed out on both the outside and inside. Then I used some zip ties to keep everything nice and tight together until it fully cured.




1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users