Jump to content


mp7 trigger how to


  • Please log in to reply
1 reply to this topic

#1 ChaosMP7

ChaosMP7

    Newbie

  • Members
  • Pip
  • 26 posts
  • Country:

Posted 09 July 2014 - 09:59 PM

I've read that some people have problems getting the trigger back in when putting the mp7 back together, so i thought i'd try and give a detailed how to as best i could.


Attached File  image.jpeg   35.75K   12 downloads
Attached File  image (1).jpeg   34.21K   11 downloads
above are picture of how the spring should be in case it falls out of the trigger.

Attached File  image (4).jpeg   36.27K   16 downloads
these are the nubs on the Trigger transfer bar (#59) that the trigger itself rest in.

Attached File  image (5).jpeg   43.27K   15 downloads
place the trigger  pretty much just resting inside

Attached File  image (6).jpeg   41.14K   12 downloads
with the gun upside down push forwards towards the front of the gun and down ( this compresses the spring and lets the nub on the trigger be pushed into the nubs on the trigger transfer bar (#59)
Attached File  image (3).jpeg   31.31K   8 downloads
While holding the trigger down and in place, keep pressure on it so it doesn't pop out as you move the trigger back towards its normal place, the more you move it towards it normal place the more the holes for the pin start to match up allowing the pin to be push in. once in check to see if the trigger reset after you pull it.

hope this helps

#2 gcw360

gcw360

    Supreme Guru

  • Super Moderator
  • PipPipPipPip
  • 11,736 posts
  • Gender:Male
  • Location:New Jersey
  • Interests:Airsoft (Especially repair and customizing), Fly Fishing, Fossils (Especially Dino), Snakes, Photography
  • Country:

Posted 11 July 2014 - 05:49 AM

Sticky.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users