Jump to content


Barrel Disassembly?


  • Please log in to reply
2 replies to this topic

#1 kwaispro727

kwaispro727

    Specialist

  • Members
  • PipPipPip
  • 970 posts
  • Gender:Male
  • Location:New Jersey
  • Interests:Fishing, swimming, airsoft, real firearms, cars
  • Country:

Posted 12 April 2014 - 02:19 PM

So I got my new barrel.  I took off the piece that floats up and down on the spring.  But I can't figure out how to get the inner barrel/hop-up assembly out, let alone into the new metal barrel.  There is some sort of pin holding it in but I'm not sure how to get it out.  Does anyone know?

#2 Pyro_Buster

Pyro_Buster

    Enthusiast

  • Members
  • PipPip
  • 125 posts
  • Gender:Male
  • Location:California
  • Country:

Posted 12 April 2014 - 02:58 PM

Not sure how the hop up unit differs on the PTP's compared to the HK45/USP, but there's a little screw in the back between the barrel and where the spring guide sits. I had to take that out when I adjusted my hop up.

#3 jtl1952

jtl1952

    Newbie

  • Members
  • Pip
  • 10 posts
  • Country:

Posted 13 April 2014 - 01:36 PM

https://www.youtube....h?v=VvTgZRZcnhc  Pick up a cheap set of metric roll pin punches, or use a drill bit that fits.  Be careful not to lose the small ball bearing (#121) when removing #34.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users