ESD EVO II Hop Housing
Posted 10 March 2014 - 07:03 PM
Would be nice to replace that junk pot metal I currently have in there. I have to order a new maple leaf hop anyway... might as well grab this too if it works.
Posted 10 March 2014 - 08:23 PM
Posted 11 March 2014 - 07:18 PM
Posted 11 March 2014 - 08:03 PM
Posted 11 March 2014 - 09:44 PM
Posted 20 March 2014 - 09:31 PM
The real benefit if having this part is for those with the EVO II kit. I can run 0.20 to 0.30g bbs without having to bend the tension arm. Takes out the guessing/testing for adjustments. However, I have not tested over 0.30g, but at full hop is still overhops 0.3s but they don't sky rocket anymore. Maybe 0.4 would be its upper limit?
Posted 28 March 2014 - 08:57 AM
Edited by Nitemare, 28 March 2014 - 08:58 AM.
Posted 19 April 2014 - 05:35 PM
The piston doesn't stick/lock to the hop/barrel after firing or pulling the charging handle at all, so my full auto is borked because it's not sealing well enough. Semi auto works fine, though every few shots it was dipping about 30 FPS. First 20 shots were also pretty sporadic, but I'm guessing this is just the initial wear-in because after that the shots were looking pretty good.
I only fired about 60 rounds because I need more BBs and time. I'm going to either bend the arm down more (because it came bent far too high, and the new housing could not accommodate it any easier than stock) or stick the stock hop housing back in and see if that makes a difference in the piston nozzle sealing or not.
Edited by Nitemare, 19 April 2014 - 05:36 PM.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users