Jump to content


USP 45 part positioning


  • Please log in to reply
No replies to this topic

#1 SilverWings

SilverWings

    Newbie

  • Members
  • Pip
  • 8 posts
  • Gender:Male
  • Location:Buffalo, NY
  • Country:

Posted 22 December 2013 - 10:01 AM

I have replaced the trigger on an HK USP 45 and after reassembly I am having the following issue. I pull the trigger and the hammer does not cycle completely through as it should and the gun will not fire. I have narrowed the problem down to part number 163 on the parts diagram listed below:

http://www.kwausa.co..._G08V01_USP.jpg

What is the correct positioning for this part inside the trigger assembly area? I can move the part around while troubleshooting the issue but can't find the right location or positioning for it. Any assistance would be greatly appreciated as this is the last part that needs to be placed correctly for the pistol to function properly. Thanks!

Steve




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users