Jump to content


Trigger Bar Plundar

KMP9R KWA trigger bar plundar

  • Please log in to reply
1 reply to this topic

#1 awmason

awmason

    Newbie

  • Members
  • Pip
  • 1 posts
  • Country:

Posted 28 November 2013 - 04:43 AM

Hi
I have had my KWA KMP9R now for a few years, but a few weeks ago my disconnector packed up and failed. I field stripped it and replaced the disconnecter with a new one, however upon reassembly I somehow missed out on putting the Trigger Bar Plundar back, and cannot seem to remember its position within the KMP9R. Due to this it is not firing and so i was wondering if anybody had any ideas as to where it goes. Any help would be greatly appreciated.
Thanks
Alex

#2 gcw360

gcw360

    Supreme Guru

  • Super Moderator
  • PipPipPipPip
  • 11,722 posts
  • Gender:Male
  • Location:New Jersey
  • Interests:Airsoft (Especially repair and customizing), Fly Fishing, Fossils (Especially Dino), Snakes, Photography
  • Country:

Posted 28 November 2013 - 10:21 AM

See here for the part, it's #155 (Trigger Bar Plunger)

http://www.kwausa.co.../mmd10_kmp9.pdf

Here is thread with a video showing the MP9 lower disassembly to replace the reset bar.  Note: This video is not entirely accurate in that you DO NOT spread the lower receiver to remove the internal assembly.  You actually need to remove the Hammer Housing Pins #56  There are two small grub screws that come out and then the pins are pried off from the inside.  That said the video should help you with the replacement of part #155

See here: http://www.kwausa.co...showtopic=11671

Hope this helps.




0 user(s) are reading this topic

0 members, 0 guests, 0 anonymous users