Bolt Return Spring (Part No. 76) Broke
Posted 29 April 2013 - 11:44 PM
So how did you get the harbor freight oring on the nozzle? If you just pulled it out till you could get to the oring fully you overly stretched it out.
This just happened to me literaly a few hrs ago, a week after swapping to the danco #10 on the nozzle and 20k rounds into it. I think some #10s are too fat causing the nozzle to pull out but not return. I just clipped the 1/8inch of messed up spring off, folded TWO coils over instead of one and reassembled. The two coils around the pins instead of one should help, only qualm is the nozzle has a "stronger" return spring now so it only pulls out about an 1/8 of an inch when the bolt cycles and snaps right back. Shot a few mins ago and there is no loss in range or fps do all seems good.
When I say the bolt, I mean the bolt and not the entire BCG. To get the oring on, I removed the c clip that attaches the bolt to the BCG...
Posted 02 May 2013 - 09:28 PM
Posted 24 May 2013 - 09:10 AM
Posted 25 May 2013 - 11:38 AM
Posted 29 May 2013 - 11:11 AM
Posted 29 May 2013 - 11:43 AM
Posted 21 July 2013 - 09:44 PM
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users