I finally got everything back as it should be, but now I'm left with part 89 out of place (pictured in my fingers) and a problematic rail:
Does anyone know how to go about a rail replacement? It looked like it was held in by a simple roll pin without part 89 in place. If I buy a new rail, will the retaining clip slide right back into place? I tried putting it there again, but it wasn't very secure.
Also, the A008 o-ring in the HF pack fits on the back of the piston spring where the c-clip usually is. Makes it very easy to put on/take off. I thought I saw this posted here once but I just wanted to be sure people knew because I couldn't find it again, or which o-ring they specifically used. It will come off if the piston spring is pulled too much (prevents damage to the spring in my opinion), but works fine with normal operation.
Edit: The rail comes with the clip attached. Need a new one to get it back in place apparently. Parts are $20 from KWA and is attached via roll pin and metal clip at the rear.
Edited by Nitemare, 12 August 2013 - 01:54 PM.