MP7 bucking question
Posted 28 January 2013 - 05:26 PM
Posted 28 January 2013 - 05:43 PM
Posted 28 January 2013 - 06:06 PM
I've never heard of an instance where the hop up bucking would swell due to using green gas. I've only seen it happen when people run propane and add lots of silicon oil. If you have to run propane, I'd recommend using green gas for the first 45 days of ownership, so your warranty is good, and then make the switch if you have to.
If you have to use propane, I'd recommend putting very little lubrication inside the gas itself, and making sure to keep a rigorous cleaning schedule to ensure it's always clean after shooting. Keeping an MP7 cleaned properly is a harder task, as getting to the inner frame is somewhat difficult, and should not be done on a regular basis. But maintaining moving parts like the bolt should be sufficient for most cleanings...
Posted 29 January 2013 - 04:27 AM
Posted 06 February 2013 - 08:43 PM
Posted 07 February 2013 - 09:06 PM
What did you use to get the 2 pins out , in order to pull the inner barrel out. I TRIED TAPPING the out but the didn't move. What kind of buking did u go with
Posted 08 February 2013 - 06:51 PM
Posted 09 February 2013 - 09:30 AM
Ehobby used to sell the bucking by itself, but now I can't find it.
Posted 11 February 2013 - 06:21 PM
I have a set of drift pins, but the first time I got the pins out I used a hex key and just tapped on it with a hammer a little bit, I just went with a replacement bucking from the pro shop, nothing fancy. I figure that if it only takes me less than an hour to change one out, on the off chance I mess up again and swell the bucking, it's five bucks and a bit of time to get to know the guns internals better.
Posted 12 February 2013 - 07:33 AM
1 user(s) are reading this topic
0 members, 1 guests, 0 anonymous users