First-gen full plastic M9
Posted 15 August 2009 - 09:53 PM
First of all, the slide catch. The slide does not lock when the magazine is empty, even after installing this spring set. Also, I am able to unlock the slide after manually locking it by simply by flicking my wrist. It's a rather old pistol, so I think I need a new slide, but I could be wrong.
The part of the slide where the catch locks onto; it looks rather worn.
Second, the decocker. For the hammer to actually raise, I need to flip the safety switch and then apply pressure to the top of the slide. Again, I installed this spring set, which made it work as described above instead of not at all. I think this could also be solved with a new slide, but I'm not sure.
Third, the right side safety lever is missing. Not really that big of an issue, but it's a bit of an eyesore. Are spares available?
Posted 23 August 2009 - 01:52 PM
You need to contact customer support, check the link below.
So a new slide will fix the first two problems I'm having?
Posted 24 August 2009 - 09:23 AM
Posted 24 August 2009 - 07:07 PM
Alright then. I'll send it in as soon as I get some money.
Edited by Murph9935, 07 October 2009 - 11:11 PM.
Posted 14 October 2009 - 08:37 PM
So, I started poking around eHobby for no reason, and I came across this slide and barrel. I figured that if I'm going to replace the slide, I might as well get a really nice one and not worry about it ever again. Will it work with my model?
I also found these high-flow valves. Will these work too? (I'm pretty sure they will, but I figured I might as well ask so I don't waste my money.)
Edited by Murph9935, 14 October 2009 - 08:37 PM.
0 user(s) are reading this topic
0 members, 0 guests, 0 anonymous users