-wigs-, on 29 April 2013 - 04:52 PM, said:
Wait you've never taken the bolt apart?
So how did you get the harbor freight oring on the nozzle? If you just pulled it out till you could get to the oring fully you overly stretched it out.
This just happened to me literaly a few hrs ago, a week after swapping to the danco #10 on the nozzle and 20k rounds into it. I think some #10s are too fat causing the nozzle to pull out but not return. I just clipped the 1/8inch of messed up spring off, folded TWO coils over instead of one and reassembled. The two coils around the pins instead of one should help, only qualm is the nozzle has a "stronger" return spring now so it only pulls out about an 1/8 of an inch when the bolt cycles and snaps right back. Shot a few mins ago and there is no loss in range or fps do all seems good.
Hmm, not sure what you're asking. But yeah, that's originally what I did with the broken spring until I got my order from Tacoma and replaced it.
EDIT: nevermind, looks like you're addressing OP. Sorry bout that
Edited by okay47, 29 April 2013 - 06:11 PM.