Jump to content


m93r ns2 upper won't slide in

m93r gbb kwa barrel ns2

  • Please log in to reply
6 replies to this topic

#1 rkshirey

rkshirey

    Newbie

  • Members
  • Pip
  • 9 posts
  • Country:

Posted 01 June 2013 - 09:10 AM

Hello! My m93r's upper will not go onto the lower, It just stop completely. I just had to replace a cracked barrel. The new barrel is slightly bent but it doesn't interfere with anything as far as I know. Please help me and thank you for your time.

#2 gcw360

gcw360

    Supreme Guru

  • Super Moderator
  • PipPipPipPip
  • 11,646 posts
  • Gender:Male
  • Location:New Jersey
  • Interests:Airsoft (Especially repair and customizing), Fly Fishing, Fossils (Especially Dino), Snakes, Photography
  • Country:

Posted 01 June 2013 - 09:29 AM

Where is the slide getting hung up?  Can you post a picture?

#3 rkshirey

rkshirey

    Newbie

  • Members
  • Pip
  • 9 posts
  • Country:

Posted 01 June 2013 - 10:04 AM

View Postgcw360, on 01 June 2013 - 09:29 AM, said:

Where is the slide getting hung up?  Can you post a picture?
Sadly, I don't have a camera. It gets hung up right before the slide lock.

#4 gcw360

gcw360

    Supreme Guru

  • Super Moderator
  • PipPipPipPip
  • 11,646 posts
  • Gender:Male
  • Location:New Jersey
  • Interests:Airsoft (Especially repair and customizing), Fly Fishing, Fossils (Especially Dino), Snakes, Photography
  • Country:

Posted 01 June 2013 - 10:40 AM

Do you have the magazine out?

#5 Jsip

Jsip

    Newbie

  • Members
  • Pip
  • 3 posts
  • Country:

Posted 02 June 2013 - 07:48 AM

This happens to me all you have to do is get that return spring in (its a pain) it is easier to do upside down' then you will get a little bit of the slide on. Then you will push the buttons on the back of the lower down, the on the bottom of the slide the spring guide will be pushed out you take that and wiggle it in then push the lock down and your good.

#6 Jsip

Jsip

    Newbie

  • Members
  • Pip
  • 3 posts
  • Country:

Posted 02 June 2013 - 07:56 AM

That's how I assemble mine

#7 Naga

Naga

    Enthusiast

  • Members
  • PipPip
  • 45 posts
  • Location:Worthington, OH
  • Interests:-Cars<br />-Airsoft<br />-Paintball<br />-Scuba diving

Posted 03 June 2013 - 10:30 PM

When I replaced my outer barrel, I had to sand a bit off the lugs to make it slide in.

Also check the pin that holds the locking piece onto the barrel.  Mine is knurled on one end, as if to make it stay in place, but it still slides out easily, and will prevent the slide assembly from going onto the frame.





Also tagged with one or more of these keywords: m93r, gbb, kwa, barrel, ns2

1 user(s) are reading this topic

0 members, 1 guests, 0 anonymous users